If your board is not covered here, or the wiring looks different, please take pictures of your machine, control panel, board, other electrical components, and wiring. If you have a 6 pin variant of the power connector, refer to the instructions for this setup, along with the Cohesion3D LaserBoard Installation Guide.
If desired, refer to the Teaching Tech video above for ideas about alternative mounting solutions. Use M4 Hex Standoffs on the panel and M4 screws to secure the board. See Installing Drivers section as well.įor the B1/M1/Moshi controller variants, the board will be larger than the standard M2Nano, so some mount modifications and/or new holes may be necessary to install the LaserBoard. If your wiring looks different than the installation guide or you have a 6-pin version, continue reading below. This variant is compatible, but will require some rewiring similar to the 6-pin version.
In some instances, the M2Nano will be wired using the two pin connector in the upper right corner and have some wires also connected to the 4 pin power connector in the lower right corner. Check the Compatibility tab on the LaserBoard product page for more variations. Identify your variant of board and wiring configuration in the Cohesion3D LaserBoard Installation Guide, then follow the instructions for replacement.
0 kommentar(er)
